Also, if running FSK and using WriteLog’s Software-generated or Hardware-generated FSK option, select AFSK TX.
AFSK TX – Select AFSK if you transmit AFSK. When 2Tone is used in a Cloned Rttyrite window, these selections have no effect. These options are only important if you are using 2Tone in the main Rttyrite window. TX Operating Mode – The options here are AFSK TX, DOOK TX, Pseudo FSK TX, and FSK TX. The Swap buttons allow you to swap Mark and Space frequency for receiving stations that are inverted.ĭisplay width in Hz – This parameter only changes the width of the 2Tone window. When running FSK, these settings are for receive only and must match the tone pair that is set in your radio. If you use Low Tones, then hit the Low button to change it to 12 Hz Mark and Space Tones. Set Mark and Space Tones – By default, 2Tone comes set for High Tones of 21 Hz for Mark and Space. On the right-side of the screen, choose the channel that is used for AFSK, only if you use AFSK transmission with 2Tone. If that doesn’t work, then try Right or Mono. Mono soundcards are rare these days, so it’s likely your audio is going to either the Left or Right channel. Mono, Left, Right – Just below the list of soundcards, select either Mono, Left or Right depending on which channel is used in your soundcard to receive RTTY (on the left). The reason for this is because NET is always on in 2Tone. NOTE: If you run AFSK transmit, it is highly recommended that you turn AFC off (top button on 2Tone window). If you transmit FSK, the Transmit Setting soundcard is not used. The Transmit Setting on the right is only needed if you are to use 2Tone in the main Rttyrite window to transmit AFSK. Select the soundcard that will be used to receive RTTY. Receive Settings, Transmit Setting – At the top of the screen under Receive Settings and Transmit Setting, are a list of soundcards installed on the computer. 
The 2Tone window looks like this.Īccess 2Tone Settings by either clicking the Setup button on the front panel or by choosing Settings under the Setup menu. Use the browse button in Setup XMMT.ocx to navigate to the location of 2Tone.exe, then click OK. First you must select XMMT.ocx in the TU type menu, then select TNC Setup in the TU Type menu. Starting 2Tone within Rttyrite is a two step process. 2Tone.PDF is located in the 2Tone folder or can be accessed via the Help menu on the 2Tone window. For installation of XMMT.ocx, MMTTY and 2Tone, click here.īefore setting up 2Tone for the first time, read the the 2Tone Help file named 2Tone.PDF. In order to run 2Tone with WriteLog, you must have the Active X control XMMT.ocx installed on your PC.
2Tone is only supported in WriteLog versions 11.10G or later beginning March 2013.
0 kommentar(er)
